3b95b8dedc
Added new VTARGET_REF_VOLTS and VTARGET_SCALE_FACTOR compile time defines to the AVRISP-MKII programmer project to set the VTARGET reference voltage and scale factor.
...
Fixed XPLAINBridge project not correctly reading the XMEGA's supply voltage when reporting back to the host.
2010-05-27 10:36:21 +00:00
8d993afc53
Replace ring buffer library in Benito and USBtoSerial projects with the new lightweight ring buffer header to improve reliability.
2010-05-26 13:26:10 +00:00
885170f5b4
Removed unused line encoding data and control requests from the CDC Bootloader code, to save space.
2010-05-26 12:44:05 +00:00
670413603f
The EEPROM stream read/write functions now use eeprom_update_byte() instead of eeprom_write_byte(), so that only changed bytes are written to EEPROM to preserve its lifespan.
...
Changed over the AVRISP-MKII and TemperatureDataLogger projects to use eeprom_update_byte() when writing non-volatile parameters to EEPROM to preserve its lifespan.
2010-05-26 11:54:55 +00:00
9c037a952f
The RingBuff library code has been replaced in the XPLAINBridge project with an ultra lightweight buffer to help improve the reliability of the bridge.
2010-05-26 06:15:05 +00:00
4a13a5484a
Fixed RNDISEthernet demos crashing when calculating checksums for Ethernet/TCP packets of more than ~500 bytes due to an overflow in the checksum calculation loop (thanks to Kevin Malec).
...
Removed string Attributes from the Service Discovery Protocol code to minimise the potential points of failure while the base code is being debugged.
2010-05-25 06:14:37 +00:00
d3699d0261
Added new ADC_DisableChannel() function (thanks to Mich Davis).
2010-05-18 12:51:31 +00:00
ff61dfa505
Fixed AVRISP project not sending a full erase-and-write EEPROM command to XMEGA targets when writing to the EEPROM instead of the split write-only command (thanks to Tim Margush).
2010-05-16 05:43:03 +00:00
80d85090ba
Fixed AVRISP project sending a LOAD EXTENDED ADDRESS command to 128KB AVRs after programming or reading from the last page of FLASH.
2010-05-14 10:11:40 +00:00
6b7770ef2b
Commit for 100513 re-release due to critical device mode bug.
2010-05-13 13:01:13 +00:00
34047efc7e
Remove incorrect check for the current device state in the Set Configuration request handler of DevChapter9, which broke Set Configuration requests to the device under most circumstances.
...
Move out the SPI prescaler list to a PROGMEM module-level variable in ISPTarget.c.
2010-05-13 12:57:49 +00:00
571159df1b
Additional fix to the AVRISP-MKII clone project for 256KB AVRs.
2010-05-13 11:14:10 +00:00
cd0093a14b
Fixed AVRISP-MKII clone project not correctly issuing SET EXTENDED ADDRESS commands when the extended address boundary is crossed during programming or readback (thanks to Gerard Sexton).
...
Fixed warnings when building the AVRISP-MKII clone project with the ENABLE_XPROG_PROTOCOL compile time option disabled.
2010-05-13 09:25:17 +00:00
1331cce08a
Fixed possible device lockup when INTERRUPT_CONTROL_ENDPOINT is enabled and the control endpoint is not properly selected when the ISR completes.
2010-05-13 07:43:18 +00:00
d3c623e1e1
The LIBUSB_FILTERDRV_COMPAT compile time option in the XPLAINBridge and AVRISP-MKII projects has been renamed LIBUSB_DRIVER_COMPAT, as it applies to all software on all platforms using the libUSB driver.
...
Fix Benito makefile which was accidentally changed during testing.
2010-05-13 07:31:27 +00:00
e277ff0cf4
Removed TeensyHID bootloader, per request from Paul at PJRC.
2010-05-12 11:12:53 +00:00
3080988b35
Commit for the 100512 release.
2010-05-12 07:30:47 +00:00
05ac59d0ee
Add new ReportType parameter to the HID class driver device callback and host report sending routines.
...
Renamed internal Host mode Class driver descriptor comparator callback routines so that they all start with a uniform DCOMP_{Class Abbreviation}_ prefix.
2010-05-09 06:01:01 +00:00
071e02c6b6
Add svn:eol-style property to source files, so that the line endings are correctly converted to the target system's native end of line style.
2010-05-08 03:12:14 +00:00
a9e0935a90
Device mode class driver callbacks are now fired before the control request status stage is sent to prevent the host from timing out if another request is immediately fired and the device has a lengthy callback routine.
...
Inlined currently unused MIDI ProcessControlRequest routine.
2010-05-07 06:54:08 +00:00
842e219bf3
Added new EVENT_CDC_Device_BreakSent() event and CDC_Host_SendBreak() function to the Device and Host CDC Class drivers.
2010-05-06 11:56:34 +00:00
9c8bd6ed9b
Remove incorrect Abstract Call Management class specific descriptor from the CDC demos, bootloaders and projects.
2010-05-06 11:32:55 +00:00
c3db72afdc
Make CDC class bootloader hard-reset the AVR when exited instead of a soft-reset. Reduce size of the TeensyHID bootloader slightly.
...
Fix the TeensyHID bootloader for the larger USB AVR devices, since Paul uses a different (undocumented) addressing scheme on these devices.
2010-05-06 07:27:13 +00:00
ab8668b14e
Removed software PDI/TPI emulation from the AVRISP-MKII clone project, as it was very buggy. PDI and TPI must now be implemented via seperate headers instead of the one unified ISP/TPI/PDI header.
2010-05-04 11:33:51 +00:00
708a1c6166
Fixed INTERRUPT_CONTROL_ENDPOINT compile time option preventing other interrupts from occuring while the control endpoint request is being processed, causing possible lockups if a USB interrupt occurs during a transfer.
2010-05-04 10:16:44 +00:00
e652cfac67
Fixed Host mode HID class driver not sending the correct report type when HID_Host_SendReportByID() was called and the HID_HOST_BOOT_PROTOCOL_ONLY compile time option is set.
2010-05-04 10:10:41 +00:00
27f0ba6fc3
Fixed device state not being reset back to the default state if the host sets the address to 0x00.
...
Fixed Set Configuration requests not being stalled until the host has set the device's address.
Fixed possibility of internal signature retrieval being corrupted if an interrupt occurs during a signature byte read (thanks to Andrei Krainev).
2010-05-04 10:07:22 +00:00
eed7d4df6a
Added new ENDPOINT_*_BusSuspended error code to the Endpoint function, so that the stream functions early-abort if the bus is suspended before or during a transfer.
2010-05-03 07:41:22 +00:00
3d28d53c3e
Change AVRISP project's timeout to be interrupt based again, but make the interrupt itself interruptable and use a seperate assembly file to hand-optimize the ISR code.
...
Removed the cast to uint16_t on the set baud rate in the USBtoSerial project, so that the higher >1M baud rates can be selected (thanks to Steffan).
2010-05-02 05:16:34 +00:00
9cad677ebb
The Audio_Device_IsSampleReceived() and Audio_Device_IsReadyForNextSample() functions are now inline, to reduce overhead.
2010-04-29 14:54:11 +00:00
9e34144c9b
Use puts_P() and printf_P() instead of the normal variants where possible in the Host mode Class Driver demos.
2010-04-28 14:33:10 +00:00
59c4871f80
USB_Init() no longer calls sei() to enable global interrupts - this must now be done in the user application once all init code has run.
2010-04-28 07:48:26 +00:00
5993e1efe7
Added ability to search by Channel PSM to the GetChannelData() function in the BluetoothHost demo.
...
Added new HCI states to properly initialize the bluetooth dongle and retrieve the local BDADDR.
Factored out Bluetooth state information into a new state structure for easy reference in the user application.
Added new StackInitialized() Bluetooth stack callback function.
2010-04-22 14:08:00 +00:00
8252b4febd
Fixed HID Device Class Driver not allocating a temporary buffer when the host requests a report via the control endpoint and the user has set the PrevReportINBuffer driver configuration element to NULL (thanks to Lars Noschinski).
...
Clean up incomplete BluetoothHost debugging commands to use GCC extension to avoid NULL parameters when no formatting is required.
2010-04-20 08:52:51 +00:00
3eb81df998
Rename FunctionAttributes.h to Attributes.h, as some attributes are applicable to variables also. Add new ATTR_NOINIT attribute for global variables.
...
Add the beginnings of a SDP implentation to the incomplete BluetoothHost demo.
Add const attribute to the Mass Storage Host driver functions where it was applicable, but missing.
2010-04-15 11:04:24 +00:00
5e14c194c9
Fixed Set/Clear Feature requests directed to a non-configured endpoint not returning a stall to the host.
...
Make TeensyHID bootloader use an 8 byte control endpoint to match the official Teensy, just in case Paul decides to authenticate on that attribute in the future.
2010-04-14 13:46:49 +00:00
7b79325aa0
Removed two-step endpoint/pipe bank clear and switch sequence for smaller, faster endpoint/pipe code.
...
Added spacing between multiple paragraphs in Doxygen \note sections.
Removed call to the clock prescaler reset function in the Teensy bootloader to save space - the user application is accessed via a watchdog reset anyway, so the prescale reset would only affect the speed of the bootloader itself.
2010-04-13 23:29:11 +00:00
19ecd04f37
Removed invalid dfu and flip related targets from the bootloaders - bootloaders can only be replaced with an external programmer.
2010-04-13 12:10:04 +00:00
ee74b4948f
Add information request/response signal handler to the Bluetooth Host demo.
...
Ensure that the AVRISP-MKII project's Windows avrdude compatibility define is named properly in all parts of the code.
2010-04-06 02:48:47 +00:00
c9148f9b47
Added WIN_LIBUSB_COMPAT compile time option to the AVRISP programmer project to make the code compatible with Windows builds of avrdude at the expense of AVRStudio compatibility.
2010-03-31 09:20:24 +00:00
61a799ed55
Added support for the JM-DB-U2 board hardware.
2010-03-30 09:28:45 +00:00
3790907f4d
Added board hardware driver support for the Benito programmer.
2010-03-30 09:08:26 +00:00
a8cbe3466b
Added board hardware driver support for Tom's USBTINY MKII programmer.
2010-03-30 08:32:46 +00:00
0557676013
Add file-level brief documentation.
...
Remove accidentally duplicated model-specific peripheral driver files.
2010-03-29 07:49:58 +00:00
74353374c3
All Class Driver Host mode demos now correctly set the board LEDs to READY once the enumeration process has completed.
...
Fixed Still Image Host class driver not resetting the transaction ID when a new session is opened, fixed driver not sending a valid session ID to the device.
2010-03-25 06:34:38 +00:00
b8db5fc1e7
Added new Relay Controller Board project (thanks to OBinou).
...
Added hardware board driver support for the PJRC Teensy line of USB AVR boards.
2010-03-24 08:06:23 +00:00
c2de01b661
Fixed incorrect definition of HID_ALIGN_DATA() causing incorrect HID report item data alignment.
2010-03-24 05:58:20 +00:00
f79f9abd28
Fixed compilation error in the AudioInput demos when MICROPHONE_BIASED_TO_HALF_RAIL is defined (thanks to C. Scott Ananian).
...
Minor documentation cleanups.
Make sure HID class driver uses properly cast pointers when writing to the report buffer.
2010-03-24 05:50:09 +00:00
c58c53dba9
Added incomplete MIDIToneGenerator project.
2010-03-23 09:16:47 +00:00
49b09a2042
Standardized the naming scheme given to configuration descriptor sub-elements in the Device mode demos, bootloaders and projects.
...
Fix errors in the MouseHostWithParser demo from incorrect use of the HID_ALIGN_DATA() macro.
2010-03-22 07:12:25 +00:00
Dean Camera